Assembly
Attach trucks to deck using the 8 screws provided. It is better to put the screws into the trucks before attaching them to the deck. Take the screws out and then attach trucks to the deck. The trucks are not pre-threaded. This is normal for all fingerboard trucks.
A P0 sized philips head screw driver will make the attachment of trucks easier.
IMPORTANT! Make sure screw goes through truck. If screws not tight, trucks will fall off.
If you are having trouble getting the trucks on,it is better to put the screws into the trucks before attaching them to the deck. Take the screws out and then attach trucks to the deck. The trucks are not pre-threaded. This is normal for all fingerboard trucks.
A P0 sized philips head screw driver will make the attachment of trucks easier.
Place the wheel onto the axle. Wide side of the wheel facing out.
Place the nut into tool and tighten wheels onto axle. Make sure nut is tight, but does not stop wheel from turning.
Remove backing from foam tape Apply to deck as shown in image.
Remove excess foam tape using nail file or fine sand paper. (not included)